Headset Pairing (3M XT-1)

Created by Josh Doten, Modified on Fri, Nov 18, 2022 at 11:24 AM by Josh Doten

Pairing Instructions
1. Login to the base station by holding down the [Mode] key while entering [1],[2],[3],[4] and then releasing [Mode].
2. Press the [Mode] Key 3 times to enter the :System Menu:
3. Select [4] - Registration and press [Enter]
4. Select [1] - Add New Headset and press [Enter]
5. Power on the headset and wait for
Troubleshooting
- Reset Headset Pairing
  (If the headset is already paired to too many base stations)
  1. Start with the Headset powered on.
  2. Press and HOLD the power button.
  3. Press and release the T1 button 2 times.
  4. Press and release the T2 button 2 times.
  5. Release the power button.
  6. The Headset LED will illuminate to solid red for 2 seconds and then it has been cleared.
- Remove Base Station Headset Registration
  (If too many headsets are paired to the base station -- no empty slots)
  1. Login to the base station by holding down the [Mode] key while entering [1],[2],[3],[4] and then releasing [Mode].
  2. Press the [Mode] Key 3 times to enter the :System Menu:
  3. Select [4] - Registration and press [Enter]
  4. Select [2] - Remove Headset and press [Enter]
  5. Select a headset serial number from the list not in use and press the [Enter] Key to remove it's registration.
  6. Attempt to pair the new headset again now that an open slot exists.