oDMB Setup

Created by Karlee Novacek, Modified on Sat, Mar 7 at 9:09 AM by Karlee Novacek

Very important that the digital TVs are on their own electrical circuit that cannot be controlled via a light switch. These need to receive constant power in order for the timers to work correctly.

We typically run one ethernet cable to the left/1st TV and plug into the "LAN IN" port, then run a separate cable from the "LAN OUT" port on the 1st TV to the "LAN IN" port on the 2nd TV.

Steps must be followed in order to ensure the timers work correctly

Factory Reset TV first - important to do this in order to wipe out any software/hidden stuff that Howard has on the TV

Steps to factory reset: turn off the TV, press MUTE, 1, 8, 2, Power On. Options > Factory Reset > Factory Reset. Power TV back on and setup.

After initial TV setup (orientation, date/time network, etc.):

Settings > On Screen Display > Message Display
- Source info OFF
Settings > System > Power Control
- Auto Power On ON
- Max Power Saving OFF
Settings > System > Fan Settings
- Fan Control Auto
- Outdoor Mode ON
Settings > System > Auto Source Switching OFF
Settings > System > Time
- DST ON
  - Start: March 2nd Sunday 2:00 AM
  - End: November 1st Sunday 2:00 AM
- Double check that the time is accurate
Settings > System > Play Via URL Launcher
- Go Back to home screen, launch URL Launcher and set new PIN (1949 or 194949)
- Install Xibo via USB or URL
  - URL
    - Go to home screen and open the "URL Launcher"
    - enter: http://menuboards.runzanational.com
    - Once the app is installed, contact an IT member to connect this to the Xibo CMS so the images play

Firmware Update (via USB) can be done at any point of this setup, will not undo any settings/Xibo install